SMC Networks SMC7724M Management Manual page 128

C
ONFIGURING THE
Fields and Attributes
• Active Status – Check this box to enable the selected port.
• RDL – Check this box to enable Remote Digital Loopback (RDL.)
RDL tests the link between the switch and the CPE by sending out,
and returning data through the CPE, over the VDSL link (see
"efm-rdl" on page 3-152.) (Default: Disabled.)
• Flow Control – This is EFM flow control and determines the
maximum speed of transmission of data from a specific switch VDSL
port to the CPE.
(Range 0 - 128 Mbps, default 100 Mbps.)
Notes: 1. If set to 0, this feature is disabled.
2. Since the maximum transmission speed of VDSL ports is
• Profile - Configures an EFM profile for the selected port.
Web Interface
Click VDSL/VDSL Port Configuration.
2-100
S
WITCH
lower than 100 Mbps, when this feature is set to default, the
actual maximum transmission rate is determined by the EFM
profile and the physical link.