Ip Commands - SMC Networks SMC7724M Management Manual

IP Commands

An IP address may be used for management access to the switch over your
network. By default, the switch's IP address is set via DHCP. If you wish to
manually configure an IP address, you need to change the switch's default
settings (IP address 0.0.0.0 and netmask 255.0.0.0) so that they are
compatible with your network. You may also need to a establish a default
gateway between the switch and management stations that exist on another
network segment.
Command
ip address
ip dhcp restart
ip default-gateway Defines the default gateway through which an
show ip interface Displays the IP settings for this device
show ip redirects Displays the default gateway configured for
ping
Note: The access mode shown in the table is indicated by these
abbreviations: NE (Normal Exec), PE (Privileged Exec),
GC (Global Configuration), IC (Interface Configuration),
LC (Line Configuration), VC (VLAN Database Configuration.)
Function
Sets the IP address for this device
Submits a BOOTP or DCHP client request
in-band management station can reach this
device
this device
Sends ICMP echo request packets to another
node on the network
IP C
OMMANDS
Mode Page
IC 3-52
PE 3-53
GC 3-54
PE 3-55
PE 3-55
NE, 3-56
PE
3-51