S
M
WITCH
ANAGEMENT
Before you can assign an IP address to the switch, you must obtain the
following information from your network administrator:
•
IP address for the switch
•
Default gateway for the network
•
Network mask for this network
To assign an IP address to the switch, complete the following steps:
1. From the Privileged Exec level global configuration mode prompt,
type "interface vlan 1" to access the interface-configuration mode.
Press <Enter>.
2. Type "ip address ip-address netmask," where ip-address is the switch IP
address and netmask is the network mask for the network. Press
<Enter>.
3. Type "exit" to return to the global configuration mode prompt. Press
<Enter>.
4. To set the IP address of the default gateway for the network to which
the switch belongs, type "ip default-gateway gateway," where gateway is
the IP address of the default gateway. Press <Enter>. In the screen
below, the IP addresses given are merely examples.
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#exit
Console(config)#ip default-gateway 192.168.1.254
Console(config)#
1-8