Snmp-Server Enable Traps - SMC Networks SMC7724M Management Manual

C L
OMMAND INE
The snmp-server host command is used in conjunction with the
snmp-server enable traps command. Use the snmp-server enable
traps command to specify which SNMP notifications are sent
globally. For a host to receive notifications, at least one snmp-server
enable traps command and the snmp-server host command for that
host must be enabled.
However, some notification types cannot be controlled with the
snmp-server enable traps command. For example, some notification
types are always enabled.
Example
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
Related Commands

snmp-server enable traps

snmp-server enable traps
Use this command to enable this device to send Simple Network
Management Protocol traps or informs (SNMP notifications.) Use the no
form to disable SNMP notifications.
Syntax
snmp-server enable traps [authentication |link-up-down]
no snmp-server enable traps [authentication | link-up-down]
• authentication - Keyword to issue authentication failure traps.
• link-up-down - Keyword to issue link-up or link-down traps.
Note: The link-up-down trap can only be enabled/disabled via the
command line interface.
Default Setting
Issue all traps.
Command Mode
Global Configuration
3-48
I
NTERFACE