Maintain The Amigo Ii; Maintenance Schedule - Rimage Amigo II User Manual

Maintain the Amigo II

Maintenance schedule

Task
Clean the Amigo II
Align the printer
Note: For information on cleaning and maintaining your printer, refer to your Everest Printer User Guide
or PrismPlus! Printer User Guide.
Everest Printer
To align your Everest Printer, refer to the following instructions.
Required tools:
T 25 Torx screwdriver
5/32" Allen wrench
1. To power on the Amigo II, press the Amigo II power switch.
2. Wait until the unit completes the initialization.
Tip: The Everest II Printer takes 1 to 2 minutes to complete the initialization.
3. Prepare the unit for alignment.
a. Manually move the lift arm to the top of the
Amigo II.
b. To place a disc in the lift arm, press the
disc up into the Lift Arm while pressing the
disc release button.
c. To open the print drawer, press the printer
button.
d. Close and re-open the door of the Amigo II.
This releases the lift arm so you can
manually move it.
110654_G
Frequency
Once a week. Remove dust from Amigo II and surrounding work
area using a lint-free cloth.
Upon installation and again if the discs are not picked correctly from
the printer tray. Refer to the procedures below for more information.
Maintain the Amigo II
Gripper Disc Release Button
Lift
Arm
5