Rimage Amigo II Reference Manual

Rimage Producer™ Family
Replace the Adhesive Back Bumper
Use this procedure to replace an adhesive back bumper in an Autostar II™, Protégé II™, Amigo II™, Producer 8100™, Producer
8100N™.
Rimage approved parts must be used for this process. The product warranty may become void if parts not approved by Rimage are
used; equipment or parts are tampered with, misused, neglected, or modified in any respect without the written consent of Rimage.
The term "Producer" is used throughout this document to refer to the Autostar II™, Protégé II™, Amigo II™, Producer 8100™,
Producer 8100N™.
Note: Your system may not look exactly like the system pictured.
Before you begin
1. Stop or pause all jobs.
2. Power off the external control center.
3. Power off the Producer.
4. Disconnect the power cord from the power outlet.
Attach the Adhesive Back Bumper
1. Open the front door of the Producer.
2. Apply 99% isopropyl alcohol to a soft, lint-free cloth.
3. Clean the area on the Producer as shown.
4. Remove the backing from the adhesive back
bumper.
5. Discard the backing.
6. Carefully place the adhesive back bumper on the
area of the frame that was cleaned with isopropyl
alcohol.
7. Press the adhesive back bumper firmly to ensure
that it is secure.
Tip: Verify that the dispenser tray does not touch
the frame when it is in the upright position.
8. Close the front door.
The Producer is ready for use.
Support information
Europe
Contact Rimage Services Europe:
www.rimage.com/support.html
Email: support@rimage.de
Tel: +49-(0) 1805-7462-43
US, Asia/Pacific, Mexico/Latin America
Contact Rimage Services:
www.rimage.com/support.html
Email: http://www.rimage.com/support_form.cfm
Tel: North America: 800-553-8312
Asia/Pacific, Mexico/ Latin America: 952-946-0004
2000183_B
Required tools:
•
99% Isopropyl Alcohol
•
Soft, lint-free cloth
Area to Clean
When you contact Rimage Services, please provide:
•
Unit serial number and software version.
•
Functional and technical description of the problem.
•
Exact error message received.
Rimage Corporation reserves the right to make improvements to the
equipment and software described in this document at any time without
any prior notice. Rimage Corporation reserves the right to revise this
publication and to make changes from time to time in the content hereof
without obligation of Rimage Corporation to notify any person or
organization of such revisions or changes.
© 2008, Rimage Corporation
Operator
Bumper
1