Operate The Amigo Ii; Powering On The Amigo Ii; Pausing The System; Loading And Unloading Discs - Rimage Amigo II User Manual

Rimage Amigo I

Operate the Amigo II

This section provides information that you need to produce CDs or DVDs with the Amigo II.

Powering on the Amigo II

1. To power on the Amigo II, press the power
switch on the rear of the Amigo II. The
Amigo II initializes.
2. To power off the Amigo II, press the power
switch again.

Pausing the system

1. To pause the Amigo II, open the door.
2. To resume operation, close the door.

Loading and unloading discs

You can load up to 100 discs in a bin. You can either remove the carousel to load discs or open the access
door to place discs in each bin.
1. Load the discs.
a. Open the door.
b. To rotate the carousel and place a bin in position to
load discs, press the operator button.
c. Place discs to be recorded in the input bin (Bin 1) of
the carousel.
Important! Place the disc with the recording side facing
down.
Note: Remove any completed discs from each bin.
Tip: Bins 2 & 3 may be either input or output bi
depending on how the software is configured.
d. Repeat steps b - c until the required bins are filled.
e. Close the door.
2. Unload the discs.
a. Open the door.
b. To rotate the carousel and place a bin in position to remove discs, press the operator button.
c. Remove the discs from the bin.
d. Repeat steps b - c until the required bins are empty.
e. Close the door.

Setting up your printing preferences

Printing Preferences allows you to set up and run your Amigo II to produce the best possible label on your
discs. Please refer to your Everest Printer User Guide or PrismPlus! Printer User Guide for specific printing
preferences instructions.
4
Power
Switch
ns,
110654_G