Maintain the Producer II
Maintenance schedule
Task
Clean the Producer II
Align the printer
Aligning the printer
Everest printer
To align your Everest Printer, use the following instructions.
Required tools:
•
T 25 Torx screwdriver
•
5/32" Allen wrench
1. To power on the Producer II, press the Producer II power switch.
2. Wait until the unit completes the initialization.
Tip: The Everest II Printer takes 1 to 2 minutes to complete the initialization.
3. Prepare the unit for alignment.
a. Manually move the lift arm to the top
of the Producer II.
b. To place a disc in the lift arm, press
the disc up into the lift arm while
pressing the disc release button.
c. To open the print tray, press the
printer button.
d. Close and re-open the door of the
Producer II. This releases the lift arm
so you can manually move it.
4. Align the printer.
a. Slowly move the lift arm down until the disc just touches the print pad.
110629_F
Frequency
Once a week. Remove dust from the Producer II and
surrounding work area.
Upon installation and again if the printed label is not
centered on the disc. Refer to the procedures below for more
information.
Maintain the Producer II
Gripper
Disc Release Button
Lift
Arm
7