Rimage Amigo II User Manual page 12

Rimage Amigo I
b. If the disc is not centered side-to-side on
the print pad, align the printer side to side.
i. Loosen the side to side screws.
ii. Slide the printer, not the drawer, until
the side edges of the disc and printer
pad are aligned.
iii. Tighten the side to side screws.
c. Using either the T25 Torx driver or the
5/32" Allen wrench, turn the front-to-back
alignment screw until the disc hangs over
the edge of the print pad by 0.010" –
0.015".
5. Raise the lift arm to the top the unit.
6. To close the print drawer, press the printer button.
7. To release the disc from the gripper, press the disc release button.
Tip: Place your hand under the disc to catch it.
8. Close the door.
8
Print Pad
Side to Side Screws
Front to Back
Alignment Screw
110654_G