Replace a Recorder on a Rimage Producer II
Replace a Recorder on a Rimage Producer II
Use this procedure to replace one or more recorders on an Autostar II™, Protégé II™ or Amigo II™.
Rimage approved parts must be used for this process. The product warranty may become void if parts not approved by Rimage are
used; equipment or parts are tampered with, misused, neglected, or modified in any respect without the written consent of Rimage.
Notes:
•
Perform this procedure for each recorder you are replacing.
•
Your system may not look exactly like the system pictured.
•
The term "Producer II" is used throughout this document to refer to the Autostar II, Protégé II or Amigo II.
Before you begin
1.
Stop or pause all jobs.
2.
Power off the Producer II.
3.
Disconnect the power cord from the power outlet.
Remove the Recorder
Caution! Some cables in this system are latched. Equipment damage may occur if cables are not disconnected
appropriately.
1.
Access the recorder cables.
a.
At the back of the Producer II, remove the Torx
T10 screws (Qty. Amigo II = 4 or 6, Autostar
II/Protégé II = 4) that hold the back panel.
b.
Lower or remove the back panel.
Amigo II (older version)
112043_D
Autostar II™, Protégé II™ or Amigo II™
Required tools:
•
Torx T10 screwdriver
Back Panel
Back Panel
© 2008, Rimage Corporation
Autostar II or Protégé II
Amigo II (newer version)
1