Rimage Amigo II User Manual page 10

Rimage Amigo I
4. Align the printer.
a. Slowly move the lift arm down until the disc just touches the print pad.
Printer
Button
Side to Side
Alignment
Print
Pad
b. If the disc is not centered side to side on the print pad, align the printer side to side.
i. Loosen the side to side screws.
ii. Slide the printer, not the print drawer,
until the side edges of the disc and
printer pad are aligned.
iii. Tighten the side to side screws.
c. Using either the T25 Torx driver or the
5/32" Allen wrench, turn the front to back
alignment screw until there is a 1/16"
(1.5mm) gap between the front edge of the
disc and the raised edge of the disc
retainer.
5. Raise the lift arm out of the way of the print drawer.
6. To close the print drawer, press the printer button.
7. To release the disc from the gripper, press the disc release button.
Tip: Place your hand under the disc to catch it.
6
Disc
Retainer
Lift
Arm
Holding
Pins
Side to Side
Screws
Front to Back Screw
110654_G
Gap