Toyota RAV4 2019 Owner's Manual page 214

212
4-5. Using the driving support systems
C Indicators
■
Operation switches
A Vehicle-to-vehicle distance
switch
B "+RES" switch
C Cruise control main switch
D
Cancel switch
E
"-SET" switch
WARNING
■
Before using dynamic radar
cruise control with full-speed
range
●
Driving safely is the sole responsi-
bility of the driver. Do not rely solely
on the system, and drive safely by
always paying careful attention to
your surroundings.
●
The dynamic radar cruise control
with full-speed range provides driv-
ing assistance to reduce the
driver's burden. However, there are
limitations to the assistance pro-
vided.
Read the following conditions care-
fully. Do not overly rely on this system
and always drive carefully.
• When the sensor may not be cor-
rectly detecting the vehicle ahead:
P.221
• Conditions under which the vehicle-
to-vehicle distance control mode
may not function correctly: P.221
●
Set the speed appropriately
depending on the speed limit, traffic
flow, road conditions, weather con-
ditions, etc. The driver is responsi-
ble for checking the set speed.
●
Even when the system is function-
ing normally, the condition of the
preceding vehicle as detected by
the system may differ from the con-
dition observed by the driver.
Therefore, the driver must always
remain alert, assess the danger of
each situation and drive safely.
Relying solely on this system or
assuming the system ensures
safety while driving can lead to an
accident, resulting in death or seri-
ous injury.
●
Switch the dynamic radar cruise
control with full-speed range setting
to off, using the cruise control main
switch when not in use.