Toyota RAV4 2019 Owner's Manual page 114

112
3-3. Adjusting the seats
will be overwritten.
■
Recall procedure
1
Check that the shift lever is in P.
2
Turn the engine switch to ON.
3
Press one of the buttons for the
driving position you want to
recall until the buzzer sounds.
■
To stop the position recall opera-
tion part-way through
Perform any of the following:
●
Press the "SET" button.
●
Press button "1" or "2".
●
Operate any of the seat adjustment
switches.
■
Seat positions that can be memo-
rized (P.108)
The adjusted positions other than the
position adjusted by lumbar support
switch can be recorded.
■
Operating the driving position
memory after turning the engine
switch to OFF
Recorded seat positions can be acti-
vated up to 180 seconds after the
driver's door is opened and another 60
seconds after it is closed again.
■
In order to correctly use the driving
position memory function
If a seat position is already in the fur-
thest possible position and the seat is
operated in the same direction, the
recorded position may be slightly differ-
ent when it is recalled.
■
When recalling the driving position
Take care when recalling the driving
position so that the head restraint does
not touch the ceiling.
■
If the battery is disconnected
The memorized positions are erased.
WARNING
■
Seat adjustment caution
Take care during seat adjustment so
that the seat does not strike the rear
passenger or squeeze your body
against the steering wheel.
Registering/recall/canceling
an electronic key to driving
position (memory recall
function)
■
Registering procedure
Record your driving position to but-
ton "1" or "2" before performing the
following:
Carry only the key you want to reg-
ister, and then close the driver's
door.
If 2 or more keys are in the vehicle,
the driving position cannot be