Control Panel And Doors - Rangemaster Kitchener 110 Dual Fuel Users Manual & Installation

To fi t the small inner burner, fi nd the larger electrode
notch in the burner rim. Line this up with the white
ignition electrode and place the inner burner on the
large base ring.
A electrode notch
Now fi t the two burner caps, making sure that they
are sitting down properly.
Grill
The grill pan and grid should be washed in hot soapy
water. After grilling meats or any foods that soil, leave
to soak for a few minutes in the sink immediately
after use. Stubborn particles may be removed from
the grid by using a nylon brush

Control Panel and Doors

Avoid using any abrasive cleaners including cream
cleaners, e.g. Cif, on brushed Stainless Steel surfaces.
For best results use a liquid detergent e.g. Domestos
Multi Surface Cleaner.
The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean hot
soapy water. Wipe with a clean dampened cloth then
polish with a dry cloth. The oven doors should only
be cleaned with a soft cloth wrung out in clean hot
soapy water.
B ignition electrode
Ovens
The ovens have removable panels that have been
coated with a special enamel that partly cleans itself.
This does not stop all marks on the lining, but helps
to reduce the amount of manual cleaning needed.
The Cook & Clean panels work better above
200°C. If you do most of your cooking below this
temperature, occasionally remove the panels and
wipe with a lint free cloth and hot soapy water.
The panels should then be dried and replaced and
the oven heated at 200°C for about one hour. This
will ensure the Cook & Clean panels are working
eff ectively.
Don't use steel wool (Brillo) or any other materials
that will scratch the surface. Don't use oven cleaning
pads.
Removing the Oven Linings
Some of the lining panels can be removed for
cleaning and for cleaning behind. Remove the
shelves fi rst.
The side panels of either oven can be removed.
Each side of the oven is fi xed with four fi xing screws.
You don't have to remove the screws to remove the
oven linings. Lift each side panel upwards and they
will slide off the screws. Then pull them forwards.
Once the linings are removed, the oven enamel
interior can be cleaned.
15