The Main Oven; Control Panel And Doors - Rangemaster Toledo 90 Dual Fuel User Manual

with the white ignition electrode and place the
inner burner on the large base ring.
A electrode notch
Now fi t the two trim rings, making sure that they
are sitting down properly.
Griddle
Always clean the griddle after use. Allow to cool
completely before removing. Immerse the griddle
plate in hot soapy water. Use a soft cloth or, for
stubborn stains, a nylon washing up brush.
NEVER USE CAUSTIC OR ABRASIVE
CLEANERS AS THESE WILL DAMAGE THE
SURFACE.

Control Panel and Doors

The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean
hot soapy water - but take care that no surplus
water seeps into the appliance. Wipe with a
clean dampened cloth then polish with a dry
cloth. The oven doors should only be cleaned
with a soft cloth wrung out in clean hot soapy
water.
Cookers with window doors
On some models the oven door front panel can
be taken off so that the glass panels can be
cleaned. If the top edge of the oven door of your
cooker has a line of holes and there are screws
in the side edges then it can be taken apart for
cleaning.
Move the cooker forward to gain access to the
sides (see the 'Moving the cooker' section of
these instructions).
B ignition electrode
Open the oven door slightly and remove the front
panel fi xing screws from the door sides (two each
side).
Carefully lift off the outer door panel. The inside
face of the glass panels can now be cleaned -
take care not to disturb or wet the door insulation.
Please note that the door is triple glazed but the
inner two panels are fi xed and should not be
separated. After cleaning carefully refi t the outer
door panel and replace the side fi xing screws.
Grill
The grill pan and grid should be washed in hot
soapy water. After grilling meats or any foods that
soil, leave to soak for a few minutes in the sink
immediately after use. Stubborn particles may be
removed from the grid by using a nylon brush.

The Main Oven

The Main oven has panels which have been
coated with a special enamel that partly cleans
itself. This does not stop all marks on the lining,
but helps to reduce the amount of manual
cleaning needed.
The Cook & Clean panels work better
above 200°C. If you do most of your
cooking below this temperature,
occasionally remove the panels and wipe
with a lint free cloth and hot soapy water.
The panels should then be dried and
replaced and the oven heated at 200°C
for about one hour. This will ensure
the Cook & Clean panels are working
effectively.
Don't use steel wool (Brillo) or any other
materials that will scratch the surface. Don't use
oven cleaning pads.
15
some window doors only