Control Panel And Doors - Rangemaster Classic 110 Deluxe Duel Fuel Users Manual & Installation

The support frame is held to the side rails by two clips
on each side.
For each side, support the side rail with one hand and
with the other hand lift the frame up and out of the
side clips.
For safety, push the side rails back into the grill
chamber.
The side rails can be removed to make cleaning the
grill chamber easer by unhooking them from the grill
chamber sides.
Slides can be wiped clean with soft cloth and mild
detergent.
Do not use any abrasive substance.
DO NOT put the side runners in a dishwasher
When you have fi nished, hook the side rails back onto
the sides of the chamber. To refi t the frame pull the
side rails forward and for each side in turn support
the side rail and press the frame down into the side
rails. Replace the grill pan.

Control Panel and Doors

Avoid using any abrasive cleaners including cream
cleaners, e.g. Cif, on brushed Stainless Steel surfaces.
For best results use a liquid detergent e.g. Domestos
Multi Surface Cleaner.
The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean hot
soapy water. Wipe with a clean dampened cloth then
polish with a dry cloth. The oven doors should only
be cleaned with a soft cloth wrung out in clean hot
soapy water.
Ovens
The ovens have removable panels that have been
coated with a special enamel that partly cleans itself.
This does not stop all marks on the lining, but helps
to reduce the amount of manual cleaning needed.
The Cook & Clean panels work better above
200°C. If you do most of your cooking below this
temperature, occasionally remove the panels and
wipe with a lint free cloth and hot soapy water.
The panels should then be dried and replaced and
the oven heated at 200°C for about one hour. This
will ensure the Cook & Clean panels are working
eff ectively.
Don't use steel wool (Brillo) or any other materials
that will scratch the surface. Don't use oven cleaning
pads.
Removing the Oven Linings
Some of the lining panels can be removed for
cleaning and for cleaning behind. Remove the
shelves fi rst.
The side panels of either oven can be removed.
Each side of the oven is fi xed with four fi xing screws.
You don't have to remove the screws to remove the
oven linings. Lift each side panel upwards and they
will slide off the screws. Then pull them forwards.
Once the linings are removed, the oven enamel
interior can be cleaned.
21