Fitting A Stability Bracket - Rangemaster Kitchener 110 Dual Fuel Users Manual & Installation

Make 10 complete (360º) turns clockwise. (This means
turning and removing the levelling tool 20 times).
Make sure you lower BOTH REAR ROLLERS. There are
two adjusting nuts, one for each roller, at both the front
bottom corners of the cooker.
Unfold the rear edge of pack base tray. Carefully push
the cooker backwards out of the base pack. Push the
cooker close to its fi nal position, leaving just enough
space to get behind it.
Conversion to LP
If the appliance is to be converted to LP gas do the
conversion at this point. See the conversion section
of these instructions.
Levelling
You are recommended to use a spirit level on a shelf in
one of the ovens to check for level.
Place the cooker in its intended position taking care not
to twist it within the gap between the kitchen units as
damage may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust
the height of the rear of the cooker use the levelling tool
supplied to turn the adjusting nuts at the front bottom
corners of the cooker.
Adjust the height of the front roller to level the cooker.
Turn clockwise to raise the cooker and anticlockwise to
lower.
When you are satisfi ed with the height and level raise
the front of the cooker by one turn of the front roller
adjuster. Screw down the front feet to meet the fl oor.
Screw the front roller adjuster anticlockwise to raise the
Check the ap pli ance is electrically safe and gas sound when you have fi nished.
INSTALLATION
front roller so that the front of the cooker is supported
on the feet, not the front roller, to prevent accidental
movement of the cooker.
Leave the levelling tool on the adjuster with the handle
of the tool facing the rear of the cooker, so that the
customer can use it if they wish to move the cooker.
Replace the drawer by locating on side runners and push
in.

Fitting a stability bracket

A stability bracket or chain (not supplied by with the
cooker) should be fi tted when the cooker is connected
to a fl exible gas supply.
When fi tting a stability bracket read these instructions
together with the leafl et supplied with the bracket.
1. Place the cooker in its intended position and level it.
2. Draw a pencil line 100mm from the front edge of the
levelling feet.
3. Mark the centre line for the bracket by measuring
550mm from the left hand side of the cooker.
4. Lower the front roller and move the cooker forward.
5. Measure back from the pencil line 550mm to locate
the front edge of the bracket. Fix the bracket to the
fl oor.
6. Measure the height from fl oor level to engagement
edge in back of cooker. Add 3mm to this dimension
and assemble the stability bracket to this height. (i.e.
from fl oor level to underside of the top member) and
ensure the bracket does not foul the oven burner
assembly.
23