Servicing; To Remove Control Panel/Hotplate - Rangemaster Kitchener 110 Dual Fuel Users Manual & Installation

WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

Servicing

BEFORE SERVICING ANY GAS CARRYING COMPONENTS.
TURN OFF THE GAS SUPPLY
Check the appliance is gas sound after completion of
service. When checking for gas leaks do not use washing
up liquid - this can corrode. Use a product specifi cally
manufactured for leak detection.
Do not use re-conditioned or unauthorised gas controls.
Disconnect from the electricity supply before
commencing servicing, particularly before removing any
of the following: - control panel, side panels, hotplate
tray or any electrical components or covers.
Before electrical re-connection, check that the appliance
is electrically safe.
Note - References to LH and RH oven apply as viewed
from the front.
Contents
1 To Remove the Control Panel
2. To Remove Hotplate
3. To Remove Side Panels
4. To Remove Ignition or light Switch
5. To Remove Clock
6. To Remove a Thermostat
7. To Change Grill Controller
8. To Change Control Taps
9. To Change Hotplate Burner Injector
10. To Change Hotplate Burner Electrode
11. To Remove or Change a Hotplate Burner.
12. To Remove an Oven Door
13. To Change Oven Door Outer Panel
14. To Change Oven Door Latch
15. To Adjust an Oven Door Catch Keep
16. To Change Oven Door Seal
17. To Remove Grill Element.
18. To Remove RH Oven Inner Back.
19. To Change Fan in RH Oven.
20 To Remove an Oven element Thermal Cut-Out.
21. To Remove RH Oven Element.
22. To Remove the LH Oven Bottom and Top Elements
23. To change oven light bulb.
1 To Remove the Control Panel
Disconnect from electricity supply.
Pull off all the control knobs.
Open the grill and right hand oven doors and remove
the 4 fi xing screws underneath the control panel.
The control panel should drop down slightly. It is held at
the top by two holes in the top edge, one at each end,
that locate on tags on the inner panel.
Clear the control panel holes from the inner panel and
pull the control panel forward.
Disconnect the wiring from the rear.
Reassemble in reverse order. When replacing leads refer
to the wiring diagram. Check operation of timer.
27
2. To Remove Hotplate
27
Disconnect from electricity supply.
28
Remove the pan supports and burner heads. Remove
28
the screws holding the hotplate burners to the hotplate.
28
Remove the 4 screws holding the hotplate tray to the
cooker.
28
28
28
28
28
28
29
29
29
29
Taking care not to damage the burner electrodes,
29
carefully lift the hotplate, from underneath disconnect
the earth lead at the right hand rear from the rear cross
29
member and withdraw the hotplate.
29
Reassemble in reverse order ensuring that the leads
30
are reconnected. Take care not to damage the ignition
electrodes of the burners.
30
It is important that the rear earthing leads are replaced
30
when the fi xing screws are refi tted as they from part of
30
the cooker earthing.
30
Check for correct burner operation.
27