Straight Stitch - JUKI HZL-DX3 Instruction Manual

Straight stitch

Pattern No. Direct 1
Standard presser
Presser foot
foot (A)
Thread tension Auto
Turn OFF the power switch
before replacing the presser
foot.
Sewing start
Pull the needle and bobbin threads under the presser
foot to the rear of the machine and lower the presser
foot to start sewing.
This means presser foot is up.
Lower the presser foot to start
sewing.
Sewing end
Stop sewing and push the thread trimming button to trim
the threads.
<by thread trimming button>
Push the thread trimming button to trim the threads.
<by foot controller>
Foot switch function
It is possible to set so that the thread is trimmed by
depressing the front section of the foot controller.
(Refer to page 77)
* You can also cut the threads by the thread cutter at
the face plate cover.
Attention
33