Changeover Of Needle Holes (Straight Stitch Slide Plate) - JUKI HZL-DX3 Instruction Manual

Changeover of needle holes (straight stitch slide plate)

How to use the straight
stitch slide plate
1 Needle hole for straight stitches
Straight stitch
slide plate
2 Normal needle hole
Patterns which can be used
with the straight stitch
selection
Do not turn the handwheel by hand when using the nee-
dle hole for straight stitches. Be aware that the needle
can come in contact with the straight stitch slide plate if
you turn the handwheel by hand.
* Change the needle hole from the needle for straight
stitches to the normal needle hole before turning the
power OFF.
It is possible to change the needle hole between the needle
hole for straight stitches and the normal needle hole without
changing the throat plate.
In the case of starting sewing from the edge of material, the ma-
terial can be smoothly sewn without being pulled into the needle
1
hole by using the needle hole for straight stitches.
It is possible to change the needle hole to be used only by
changing over the lever position.
Lever
1
2
* In the case of the needle hole for straight stitches, any
2
After you have changed the needle hole to the needle hole for straight stitch-
es, press
Select a pattern with
pattern.
When moving the lever 2 back to the right while the screen shows left figure,
press .
Attention
Lift the needle and the presser foot.
1 By moving the lever to the left: The needle
hole for straight stitches is selected.
2 By moving the lever to the right while
slightly pushing it away from you: The
normal needle hole is selected.
pattern other than those that are available under the
straight stitch mode cannot be selected.
If the needle hole is changed over to the one for straight
stitches when any pattern other than those that are
available under the straight stitch mode, the message
will be displayed on the screen.
1. The screen will be restored to the normal one by return-
ing the lever to the right.
2. The screen will be changed over to the Direct 1 when
is pressed.
to display the patterns that can be used.
or and press to confirm the
15