Straight Stitch Slide Plate; Adjusting The Position Of The Straight Stitch Slide Plate - JUKI HZL-X Series Service Manual

6-21 Straight stitch slide plate

6-21-1 Adjusting the position of the straight stitch slide plate

○ Remove the throat plate.
Adjustment procedure
1. Temporarily tighten the setscrew 1 of the lever holder.
2. Move operating lever 3 to the left to set straight stitch slide plate 2 in the "straight stitch selection".
3. Adjust the vertical position of lever holder 4 so that the edge of needle hole in straight stitch slide plate 2
protrudes from the edge of needle slot in the throat plate by 0 to 0.2 mm. Then, tighten the setscrew 1 of
the lever holder.
4. Move operating lever 3 to the right to release the "straight stitch selection" of straight stitch slide plate 2 .
Check to be sure that the top end of straight stitch slide plate 2 does not protrude from the needle slot in
throat plate.
4
Back surface of throat plate
0 to 0.2 mm
2
– 35 –
1
Top end of 2 must nut protrude.
2
3
2
3
2