Operation - Superior Fireplaces BGE18NE Installation And Operation Instruction Manual

NOTICE: During initial operation
of new heater, burning logs will
give off a paper-burning smell.
Orange fl ame will also be pres-
ent. Open damper or window to
vent smell. This will only last a
few hours.
WARNING:
• If fi replace has glass doors,
never operate this heater with
glass doors closed. If you
operate heater with doors
closed, heat buildup inside
fi replace will cause glass to
burst. Make sure there are no
obstructions across open-
ings of fi replace.
• You must operate this heater
with a fireplace screen in
place. Make sure fi replace
screen is closed before run-
ning heater.
WARNING: Damper handle
will be hot if heater has been
running.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fi re or explosion may result
causing property damage, per-
sonal injury or loss of life.
22

OPERATION

A. This appliance is equipped with an igni-
tion device which automatically lights
the pilot. Do not light pilot by hand.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the fl oor because some
gas is heavier than air and will settle
on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fi re department.
C. Do not use this appliance if any part
has been under water. Immediately call
a qualifi ed service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
1. STOP! Read the safety information.
2. Make sure equipment shutoff valve is
fully open.
3. Press any button on the remote to power
the remote on. Press the MODE zone or
the MODE/SET Button to start the unit.
You will hear a beep from the control
module and the pilot will start to light the
unit.
NOTE: You may be running this heater
for the fi rst time after hooking up to gas
supply. If so, you may have to restart the
unit several of times to allow the air to
bleed from the system.
1. Once you have activated the screen press
the MODE Zone or MODE/SET Button
until you see OFF.
2. Close equipment shutoff valve.
SuperiorFireplaces.us.com
LIGHTING
INSTRUCTIONS
TO TURN OFF GAS
TO APPLIANCE
900703-00C