Superior Fireplaces BGE18NE Installation And Operation Instruction Manual page 17

INSTALLATION
Continued
FIBER LOG MODELS
LBG(18,24,30,36)SM
NOTE: Your appliance may vary from model
shown but log placement will be the same.
1. Place bottom log in center of the base
assembly as shown in Figure 24. The log
must sit fl at on the black sheet metal and
behind the left metal tab as shown in Figure
24-a.
2. Rest rear log in back corner sections of
base assembly as shown in Figure 24.
Make sure log is completely vertical and
not leaning in toward burner where fl ame
will touch the log.
3. Position front right log against right side of
grate prongs (see Figure 24).
4. Position front left log against left side of
grate prongs (see Figure 24).
Metal Tab
Figure 24-a - Installing Log Set
Front Left
Log
Grate
Prongs
Bottom Log
Base Assembly
Figure 24 - Installing Log Set
900703-00C
5. Place middle right log over front right and
bottom logs as shown in Figure 25. Be
sure hole in middle right log seats over pin
in bottom log.
6. Place middle left log over front left and
bottom logs as show in Figure 25. Be sure
hole in middle left log seats over pin in front
left log.
7. For LTF36SM, the front right and left
logs are longer and are supported with
brackets on each end (see Figure 26).
Place left and right small front logs under
left bracket and beside right bracket.
8. For LBG36SM, position left and right
control cover logs as shown in Figure
27. These may be placed as desired to
hide controls.
Middle
Left Log
Ramp
Log
Pin on Front
Left Log
Rear Log
Figure 25 - Installing Log Sets
Left Small
Front Log
Left Control
Cover Log
Right Control
Front
Cover Log
Right Log
Figure 26 - Installing LBG36SM Model
SuperiorFireplaces.us.com
Middle Right Log
Bracket
Bracket
Right Small Front Log
Control Cover Logs
Bottom
Log
17