Superior Fireplaces BGE18NE Installation And Operation Instruction Manual page 27

Flame-A (or Main) Adjustment
• Transmits a flame height setting com-
mand to the control module to adjust the
Flame-A height.
• Available settings are 1-3 with a factory
default of 3. Refer to the THERMOSTAT
Mode section for additional details on
fl ame modulation in THERMOSTAT mode.
• While in MANUAL ON, THERMOSTAT
ON, or PROGRAM ON modes, touch the
FLAME Zone to enter Flame-A Adjust-
ment, then press the UP or DOWN buttons
to raise and lower the fl ame; press the
MODE/SET Button or wait for 15 seconds
to accept the new setting.
• LCD Display: When setting the Flame-A
height, the Flame-A icon, and Flame-A set-
ting number will fl ash in the FLAME Zone.
Child-Lock Operation
• Child-Lock operation prevents any user
input to the transmitter. No mode of op-
eration or feature may be adjusted when
Child-Lock is activated. All automatic
functions (thermostat, program, etc.) will
continue normally.
• To activate or deactivate the Child-Lock
feature, press and hold the MODE/SET
and DOWN Buttons simultaneously for
5 seconds.
• LCD Displays:
• When activated, the LOCK icon will
appear in the MODE Zone.
• If any touch-zone or button is pressed
when activated, the LCD backlight will
illuminate and the LOCK icon will fl ash
for 5 seconds in the MODE Zone.
Room Temperature Limit
• The Room Temperature Limit Shutdown
feature will operate in MANUAL ON,
THERMOSTAT ON mode, and PROGRAM
ON modes. If the room temperature
reaches 95 deg. F or greater, the transmit-
ter will automatically change to MANUAL
OFF mode and send a MANUAL OFF
command to the control module. If the
user turns the control back ON and the
room temperature is still 95° F or greater,
the transmitter will switch to back manual
OFF and send another OFF command the
next time the transmitter reads & updates
the room temperature (2-minute update
interval).
900703-00C
OPERATION
Continued
LEARN PROCESS (PAIRING THE
REMOTE TO THE CONTROL
MODULE)
NOTE: The transmitter must be in the "OFF" or
"THERMO OFF" in order to allow the remote
to pair with the control module.
To pair the remote transmitter to the control
module, press the learn switch and release.
There should be an audible beep indicating
the module is ready to accept a transmitter
code. Next, press the mode/set button twice
on the transmitter within 60 seconds to send
a signal (the "MODE/SET" button must be
pressed once to activate the screen [lights up]
and then a second time for the remote and
module to pair). If the signal is received, the
module should beep indicating the signal was
received. NOTE: Module will remain "Open"
and ready to accept a signal for 60 seconds
after the learn switch is pressed.
The control module will learn up to 3 different
transmitter security codes (only one may be
a thermostat style).
Press and hold in the learn switch in for 6
seconds to clear all transmitter security codes
retained in memory. After releasing the switch,
three series of beeps will be heard. This
serves as proof that the transmitter's secu-
rity codes have been cleared from memory.
Repeat learn process as needed.
ON/OFF Switch turns the burner on
and off
Hi (Off) / Low (On) Switch controls the
main burner fl ame height
Momentary Switch (Learn) is for pro-
gramming the remote (see instructions
above).
SuperiorFireplaces.us.com
Unit Mounted Switches
Burner Hi-Lo Learn
27