Table of Contents
Advertisement
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fi re or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the fl oor because some
gas is heavier than air and will settle
on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fi re department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn by
hand, don't try to repair it, call a quali-
fi ed service technician or gas supplier.
Force or attempted repair may result
in a fi re or explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualifi ed service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
LIGHTING
INSTRUCTIONS
NOTICE: During initial operation
of new heater, burning logs will
give off a paper-burning smell.
Orange fl ame will also be pres-
ent. Open damper or window to
vent smell. This will only last a
few hours.
24
OPERATION
WARNING:
• If fi replace has glass doors,
never operate this heater with
glass doors closed. If you
operate heater with doors
closed, heat buildup inside
fi replace will cause glass to
burst. Make sure there are no
obstructions across open-
ings of fi replace.
• You must operate this heater
with a fireplace screen in
place. Make sure fi replace
screen is closed before run-
ning heater.
NOTE: Homeowners generally prefer to operate
their heater with the chimney damper closed.
This will put all the heat into the room. However,
there may be times you will desire the full fl ames
of the HI heat setting but will fi nd the heat output
excessive. You can open the chimney damper (if
you have one) fully or partially to release some
of the heat.
WARNING: Damper handle
will be hot if heater has been
running.
1. STOP! Read the safety information.
2. Make sure equipment shutoff valve is fully
open.
3. Press in and turn control knob clockwise
Figure 40 - Control Knob and Igniter
SuperiorFireplaces.us.com
to the OFF position (see Figure 40).
Control Knob
Flame
Igniter
Adjustment
Button
Knob
Button Location
126829-01B
Advertisement
Table of Contents
