Power Supply And Battery Installation - Superior Fireplaces BGE18NE Installation And Operation Instruction Manual

PRESSURE TESTING HEATER GAS
CONNECTIONS
1. Open equipment shutoff valve (see Figure
14, Page 15).
2. Open main gas valve located on or near
gas meter for natural gas or open propane/
LP supply tank valve.
3. Make sure control knob of heater is in the
OFF position.
4. Check all joints from equipment shutoff valve
to gas valve (see Figure 15 Or 16, Page 15).
Apply noncorrosive leak detection fl uid to all
joints. Bubbles forming show a leak.
5. Correct all leaks at once.
6. Light heater (see Operation, Page 22 de-
pending on your model). Check all other
internal joints for leaks.
7. Turn off heater (see To Turn Off Gas to
Appliance, Page 22.
POWER SUPPLY AND BATTERY IN-
STALLATION
It is helpful to have a fl ashlight so you can
see the connections as described below. Lo-
cate the battery power supply. It is the black
box with the red and black wires. Locate the
control module (see Figure 21). Connect the
battery power supply to the control module
by plugging the battery power supply to the
mating receptacle on the control module.
The receptacle is located on the side of the
black control module next to the word "BATT"
which is molded in the control module's black
housing (see Figure 21). Be certain to push
the plug fully into the receptacle. Install bat-
teries in the battery power supply and hand
held remote control. Place the battery box so
it is located away from the burner as much
as possible towards the back left side of the
fi replace fl oor.
Connect Battery Plug Here
Figure 21 - Control Module
16
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifi cally approved with
this heater may result in property
damage or personal injury.
BGE Series Burner System - Log
Burner System
Models
BGE18NE
BGE18PE
BGE2436NE
BGE2436PE
Figure 22 - BGE Series Burner System-
Log Support Brackets
If installing a LBG36SM, attach log support
brackets before installing logs. These brack-
ets are provided with the BGE2436 series
burner systems.
1. Install left bracket to left side of chassis using
2 screws provided (see Figure 23).
2. Install right bracket to right front of chassis
using 2 screws provided (see Figure 23).
This bracket will also be used as remote
control bracket if remote is installed.
Left Log
Support
Bracket
Right Front of Chassis
Figure 23- Installing Log Support Brackets
SuperiorFireplaces.us.com
Compatibility Chart
Fiber Log Concrete Log
Models
LBG18SM LBG18BM
LBG24SM
LBG24BM
LBG30SM
LBG30BM
LBG36SM
Log Compatibility Chart
Chassis
Models
Right Log
Support
Bracket
900703-00C