Superior Fireplaces BGE18NE Installation And Operation Instruction Manual page 21

chunks as shown in Figure 40 on Page 21
by placing the ember chunk with the number
"1" on the left, "2" in the center, and "3" on
the right. These numbers are embossed
on the back of each piece for identifi cation
purposes. Please note that BGE18 burner
systems do not include ember chunks.
2. Two ember materials are supplied with
this log set. Platinum Bright Embers give a
bright glow appearing as hot coals. Should
embers need replacing, see Parts, Page 41.
Platinum Bright Ember placement. Add
embers to front, fl at burner. Gently remove
embers from bag. Separate pieces of
ember material and place on surface of
fl at burner just behind horizontal ports as
shown in Figure 41.
Ember Chunk #1
Figure 40 - Ember Chunk Placement SVFS36 Series
Ember Material
Glowing Embers
Figure 42 - Placement of Glowing Embers (shown with Platinum Bright Embers)
900703-00C
INSTALLATION
Continued
3. Add volcanic stone and small decorative
Ember Chunk #2
Figure 41 - Platinum Bright Embers
SuperiorFireplaces.us.com
Glowing embers (rockwool) placement.
Place glowing embers material on front
fl at burner in areas away from ports as
shown in Figure 42.
logs around base of heater if desired. DO
NOT place volcanic stone or additional
logs on front burner or on logs.
Placing any material on unit other than
ember material on front burner may result
in production of carbon monoxide or soot.
Use volcanic stone to hide wires from
switch/log to control valve. Place switch/
log so the switch is easy to access.
Ember Chunk #3
Flat Front Burner
Flat Front Burner
21