Superior Fireplaces BGE18NE Installation And Operation Instruction Manual page 18

LBG(18,24,30)SM MODELS
LBG36SM MODELS
Figure 27 - Correct Log Placement
CONCRETE LOG MODELS
LBG(18,24,30)BM
NOTE: Your appliance may vary from model
shown but log placement will be the same.
1. Before placing any logs on the chassis you
will need to remove the Air Shield located
on the left side near the rear burner as
shown in Figure 28. The Air Shield is held
in place with one screw, remove the Air
Shield and place the screw back into the
hole in the chassis. Place the Air Shield
with your owner's manual and keep.
2. Place fi ber ramp log in center of chassis
as shown in Figure 29. The fi ber ramp
log can be identifi ed by the shape and
much lighter weight when compared to
the other logs. The log must sit fl at on the
black sheet metal and behind the left metal
tab as shown. Make sure the side marked
''BOTTOM'' is setting down.
Screw
Air Shield
Figure 28 - Removing Air Shield
18
INSTALLATION
Continued
Ramp Log
Metal
Tab
Figure 29 - Installing Fiber Ramp Log
3. Place front left and front right logs as shown
in Figure 30.
Left Front
Log
Figure 30 - Installing Left/Right Front Logs
4. Place left ember bed log as shown in Fig-
ure 31. The log has groove on one side
that sets on the ember bed pan. The back
side of this log needs to rest against the
front of the base assembly. Make sure the
fl ame from the ember pan does not touch
the ember bed log.
Figure 31 - Installing Left Ember Bed Log
5. The right ember bed log 24" & 30'' (D-047)
has a hole in the log that sets on the grate
fi nger and the other end rests on the fi re-
place fl oor, place log as shown in Figure
32, Page 19.
SuperiorFireplaces.us.com
Right Front Log
Left Ember
Bed Log
900703-00C