Installing The Power-Adapter Port; Palm-Rest And Keyboard Assembly; Removing The Palmrest And Keyboard Assembly - Dell Vostro 3515 2V448 Service Manual

Installing the power-adapter port

Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the power-adapter port and provides a visual representation of the installation
procedure.
Steps
1. Using the alignment post, place the power-adapter port into its slot on the palmrest and keyboard assembly.
2. Connect the power-adapter port cable to the connector on the system board.
3. Fold the right hinge down and install the two (M2.5x5) screws to secure it to the palmrest and keyboard assembly.
Next steps
1. Install the base cover.
2. Install the SD card.
3. Follow the procedure in

Palm-rest and keyboard assembly

Removing the palmrest and keyboard assembly

Prerequisites
1. Follow the procedure in
2. Remove the SD card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the M.2 2230 solid-state
After working inside your
Before working inside your
drive.
computer.
computer.
Removing and installing components 75