Power-On Self Test - IBM Quietwriter III 5202 Manual

Power-On Self Test
Each time the printer Power switch is turned on, the printer performs -..
6-14
the Power-On Self Test. Immediately after the printer Power switch is
turned on, the following actions occur:
1. All printer lights come on and then go off.
2. The printer beeps.
3. The carrier moves to the left and then back to the center.
4. The platen moves back and forth.
If there are no hardware failures or operator-correctable errors, all
the lights go off, except Ready and one print mode light (Draft,
Quality, or Enhanced) .
If a hardware failure is detected during this test, all lights will blink
and the printer will beep continuously for six seconds. Have your
printer serviced.
If there is an operator-correctable error or a possible hardware
failure , the
Ready
light will go off and the printer will beep. Go to
Step 1 on page 6-4.
Note: If the test indicates an error, make sure you do not have a
pluggable cartridge installed. If you do, remove it and run the test
again.
,--,.
----
' " """