Table of Contents
Advertisement
6-4
1.
Turn the printer off and do the following
checks:
a.
Make sure the printer power cord is plugged into the
back
of
the
printer.
b.
Make sure the printer power cord is
completely
plugged into
a wall outlet.
c.
Make sure any other
equipment
plugged into the same wall
outlet
operates.
d
.
Make sure the wall outlet does not turn off wi th the room
lights or
other
switches.
e.
Plug the printer into a different wall outlet.
f.
Make sure your
printer
cable is correctly connected from
your computer to your
printer.
g.
Make sure the printer top cover is completely
l
atched
down.
Did you find any problem while following the above
steps?
No
-
Go to Step
2.
Yes
- Correct the problem and try to print again
.
2.
Turn off the Power switches on the printer and
computer
(and
expansion
unit,
if
attached).
3.
Disconnect the printer cable from the printer and make sure
that
nothing else is attached to the
connector.
Grounding
Wire
111
I
11 I
I
I I 11 1111111 I 111 I 11 111111 I I
r-- - - -
Printer
Cab le
4.
Turn on the printer Power
switch.
After a few
moments,
all lights go off except
Ready
and one of the
print mode lights
(Draft, Quality,
or Enhanced).
Are there only two lights still on
(Ready
and one print mode
light)?
,......,
Advertisement
Table of Contents
