Connecting A Programming Console - Omron SYSMAC CPM2B-S001M-DRT Operation Manual

System Configurations
Expansion I/O Boards
1-2-3
CQM1H-PRO01-E
CQM1-PRO01-E
C200H-PRO27-E
Downloaded from Elcodis.com electronic components distributor
Expansion I/O
Board
32 I/O points
(16 inputs,
16 outputs)
Note When an NT-AL001-E Adapter is connected to the RS-232C port, only one
Expansion I/O Board can be connected because of power supply limitations.
Refer to the CPM2B Operation Manual (W371) for details on Expansion I/O
Board specifications and mounting instructions.

Connecting a Programming Console

A Programming Console can be connected to the CPM2B-S CPU Board's
peripheral port, as shown below.
Attached
cable (2 m)
C200H-CN222 (2 m) or
C200H-CN422 (4 m)
Connecting Cable
CS1W-CN224 (2 m) or
CS1W-CN624 (4 m)
Connecting Cable
Note 1. Only the peripheral port connector can be used when a CPM2C-CN111
Connecting Cable is connected.
2. Refer to the CPM2B Operation Manual (W371) or the CPM2C-S Operation
Manual (W377) for Programming Console operating procedures.
Inputs
16 inputs, 24 V DC
16 inputs, 24 V DC
CS1W-CN114
Connecting Cable
(0.05 m)
Dip Switch
Peripheral port
connector
CPM2C-CN111
Connecting Cable
(0.1 m) (See note 2.)
Section 1-2
Outputs
16 relay outputs CPM2B-32EDR
(terminal block)
16 sinking transistor CPM2B-32EDT
outputs (connector)
Peripheral port
IN000CH IN001CH IN002CH
OUT010CH OUT011CH OUT012CH
CPM2B-S CPU Board
Model
9