Omron SYSMAC CPM2B-S001M-DRT Operation Manual page 56

Wiring and Connections
Inserting and Removing
I/O Connectors
3-5-2-1
44
Downloaded from Elcodis.com electronic components distributor
When inserting a cable, first open the lock levers on each side of the connec-
tor and then insert the cable's connector. Press the cable's connector firmly
until both lock levers lock onto the connector.
To remove the cable, open the lock levers to the left and right before removing
the cable's connector.
Wire inputs to the CPM2B-S CPU Board and Expansion I/O Boards as shown
in the following diagrams.
Note Refer to the CPM2B Operation Manual (W371) for details on wiring inputs to
Expansion I/O Boards.
CPU Board I/O Connector Wiring
Wire the CPU Board's I/O Connector (6 inputs and 4 outputs) as shown in the
following diagram.
IR 010 (outputs)
COM1
IR 000 (inputs)
24 VDC
24 VDC
L L L L
NC
19 17 15 13 11 9 7 5 3
20 18 16 14 12 10 8 6 4
NC NC NC NC NC NC
Section 3-5
Diagram shows connector on
the Board as viewed from the
1
side from which the external
connector is inserted.
2