Connecting The Programming Console - Omron CPM1A Operation Manual

Using a Programming Console
Startup Operating Mode

4-2-3 Connecting the Programming Console

Panel Installation
The operating mode of the CPM1A when the power is turned ON depends upon
the PC Setup setting in DM 6600 and the Programming Console's mode switch
setting if the Programming Console is connected.
PC Setup setting
(DM 6600)
0000
0100
0200
0201
0202
Note The default setting is 0000. If a Programming Console is not connected, the PC
will automatically enter RUN mode. Be sure that it is safe for the PC to operate
before turning on the PC without a Programming Console connected.
Connect the Programming Console's connecting cable to the CPM1A's periph-
eral port, as shown below.
The C200H-PRO27-E Programming Console can be installed in a control panel
as shown in the following diagram. (The C200H-ATT01 Mounting Bracket is sold
separately.)
Panel thickness: 1.0 to 3.2 mm
Programming
Console connected
The startup mode
determined by the
mode switch setting.
The startup mode is the same as the operating mode before
power was interrupted.
PROGRAM mode
MONITOR mode
RUN mode
Mounting Bracket
Two screws
Section 4-2
Programming Console not
connected
RUN mode if no Programming Device
is connected. PROGRAM mode if
another Programming Device is
connected.
Mounting hole dimensions
(DIN43700 standards)
+1.1
186
–0
+0.8
92
–0
87