Installing The Cpm2B-S - Omron SYSMAC CPM2B-S001M-DRT Operation Manual

Installing the CPM2B-S

Installing the Expansion I/O Connecting Cables
3-4

Installing the CPM2B-S

38
Downloaded from Elcodis.com electronic components distributor
1,2,3... 1. Insert the Expansion I/O Cable into the connectors on the CPU Board and
Expansion I/O Board.
The cable from the CPU Board
connects to the upper Expansion
I/O Connector (the one with the
short locks.)
2. Push the cable's connector into the Board's connector until both lock levers
lock solidly.
To remove the Expansion I/O Cable, open the connectors lock levers and
pull out the cable's connector.
Install the CPM2B-S as shown in the following diagram. The CPM2B-S cannot
be installed on DIN Track.
CPU Board
Expansion
Expansion I/O Cable
I/O Board
(included with the Expansion
I/O Board)
Install the shorter connector of
the cable in the lower Board and
the longer connector in the up-
per Board.
174
Section 3-4
Lock lever
Lock lever
Four M4 screws
CPM2B-ATT01
Mounting Bracket
100