ZyXEL Communications GS1920v2 Series User Manual page 437

Figure 319 MAINTENANCE > Configuration > Configure Clone
The following table describes the labels in this screen.
Table 244 MAINTENANCE > Configuration > Configure Clone
LABEL DESCRIPTION
Configure Clone
Source/ Enter the source port under the Source label. This port's attributes are copied.
Destination
Enter the destination port or ports under the Destination label. These are the ports which are going
Port to have the same attributes as the source port. You can enter individual ports separated by a
comma or a range of ports by using a dash.
Example:
2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
2-6 indicates that ports 2 through 6 are the destination ports.
Port Features
Select a feature's check box to select a specific feature. Otherwise, select the check box in the
table heading row to select all features for a category.
SYSTEM Select the system feature (you configured in the SYSTEM menus) to be copied to the destination
ports. Otherwise, select the SYSTEM check box in the table heading row to select all features for a
category.
Chapter 67 MAINTENANCE
GS1920v2 Series User's Guide
437