ZyXEL Communications GS1920v2 Series User Manual page 96

Figure 62 MONITOR > Neighbor > Neighbor Details (example PoE model)
The following table describes the fields in the above screen.
Table 19 MONITOR > Neighbor > Neighbor Details
LABEL DESCRIPTION
Search Ports... Enter the port number to search and display the ports you specified. The result will display
in the below list.
You can enter multiple ports separated by comma (",") or hyphen ("-") for a range. For
example, enter "3-5" for ports 3, 4, and 5. Enter "3,5,7" for ports 3, 5, and 7.
Port This shows the port of the Switch, on which the neighboring device is discovered.
Desc. This shows the port description of the Switch.
Link Speed This shows the speed (either 10M for 10 Mbps, 100M for 100 Mbps, 1G for 1 Gbps, 2.5G for
2.5 Gbps, 5G for 5 Gbps, or 10G for 10 Gbps) and the duplex (F for full duplex or H for
half). This field displays Down if the port is not connected to any device.
PoE Draw (W) For PoE models.
This shows the consumption that the neighboring device connected to this port draws
from the Switch. This allows you to plan and use within the power budget of the Switch.
Reset Click this button to turn OFF the power of the neighbor device and turn it back ON again.
A count down button (from 5 to 0) starts.
Note: The Switch must support power sourcing (PSE) or the network device is a
Remote
System Name This shows the system name of the neighbor device.
Port Bridge This shows the neighboring device's MAC address or the port number connected to the
Switch.
Model This shows the model name of the neighbor device. This field will show "–" for devices that
do not support the ZON utility.
MAC This shows the MAC address of the neighbor device.
Firmware This shows the firmware version of the neighbor device. This field will show "–" for devices
that do not support the ZON utility.
Chapter 12 Neighbor
powered device (PD).
GS1920v2 Series User's Guide
96