Add/Edit Subnet Based Vlan - ZyXEL Communications GS1920v2 Series User Manual

The following table describes the labels in this screen.
Table 163 SWITCHING > VLAN > Subnet Based VLAN Setup
LABEL
Active
DHCP-VLAN
Override
Apply
Cancel
Index
Active
Name
IP
Mask-Bits
VID
Priority
Add/Edit
Delete

49.8.1 Add/Edit Subnet Based VLAN

Click Add/Edit, or select an entry and click Add/Edit in the SWITCHING > VLAN > Subnet Based VLAN
Setup screen to display this screen.
Figure 219 SWITCHING > VLAN > Subnet Based VLAN Setup > Add/Edit
Chapter 49 VLAN
DESCRIPTION
Enable the switch button to activate this subnet based VLANs on the Switch.
When DHCP snooping is enabled DHCP clients can renew their IP address through the DHCP
VLAN or through another DHCP server on the subnet based VLAN.
Enable the switch button to force the DHCP clients in this IP subnet to obtain their IP
addresses through the DHCP VLAN.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This is the index number identifying this subnet based VLAN.
This field shows whether the subnet based VLAN is active or not.
This field shows the name the subnet based VLAN.
This field shows the IP address of the subnet for this subnet based VLAN.
This field shows the subnet mask in bit number format for this subnet based VLAN.
This field shows the VLAN ID of the frames which belong to this subnet based VLAN.
This field shows the priority which is assigned to frames belonging to this subnet based VLAN.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Add/Edit to add a new entry or edit a selected one.
Click Delete to remove the selected entry.
GS1920v2 Series User's Guide
306