Lldp-Med Setup - ZyXEL Communications GS1920v2 Series User Manual

Table 85 PORT > LLDP > LLDP > Org-specific TLV Setting (continued)
LABEL
Port-Protocol
VLAN ID
Port VLAN ID
Dot3 TLV
Link
Aggregation
MAC/PHY
Max Frame Size
Apply
Cancel

31.8 LLDP-MED Setup

Click PORT > LLDP > LLDP MED > LLDP-MED Setup to display the screen as shown next.
Figure 126 PORT > LLDP > LLDP MED > LLDP-MED Setup
Chapter 31 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
Select the check boxes to enable or disable the sending of IEEE 802.1 Port and Protocol VLAN
ID TLVs on the ports.
Select the check boxes to enable or disable the sending of IEEE 802.1 Port VLAN ID TLVs on
the ports. All check boxes in this column are enabled by default.
Select the check boxes to enable or disable the sending of IEEE 802.3 Link Aggregation TLVs
on the ports.
Select the check boxes to enable or disable the sending of IEEE 802.3 MAC/PHY
Configuration/Status TLVs on the ports. All check boxes in this column are enabled by default.
Select the check boxes to enable or disable the sending of IEEE 802.3 Max Frame Size TLVs on
the ports.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS1920v2 Series User's Guide
186