Mvr Group Setup - ZyXEL Communications GS1920v2 Series User Manual

Table 121 SWITCHING > Multicast > MVR > Add/Edit (continued)
LABEL
None
Tagging
Apply
Clear
Cancel

39.13 MVR Group Setup

All source ports and receiver ports belonging to a multicast group can receive multicast data sent to this
multicast group.
Use this screen to view and configure MVR IP multicast group settings. Click SWITCHING > Multicast >
MVR > Group Setup to access this screen.
Note: A port can belong to more than one multicast VLAN. However, IP multicast group
addresses in different multicast VLANs cannot overlap.
Figure 170 SWITCHING > Multicast > MVR > Group Setup
The following table describes the labels in this screen.
Table 122 SWITCHING > Multicast > MVR > Group Setup
LABEL
MVLAN
Group Name
Start Address
End Address
Chapter 39 Multicast
DESCRIPTION
Select this option to set the port not to participate in MVR. No MVR multicast traffic is sent or
received on this port.
Select this check box if you want the port to tag the VLAN ID in all outgoing frames
transmitted.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
DESCRIPTION
This field displays the multicast VLAN ID.
This field displays the descriptive name for this setting.
This field displays the starting IP address of the multicast group.
This field displays the ending IP address of the multicast group.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
GS1920v2 Series User's Guide
242