Add/Edit A Static Mac Filtering Rule - ZyXEL Communications GS1920v2 Series User Manual

Table 152 SWITCHING > Static MAC Filtering (continued)
LABEL
Add/Edit
Delete

47.2.1 Add/Edit a Static MAC Filtering Rule

Use this screen to create or edit rules for traffic going through the Switch. Click Add/Edit, or select an
entry and click Add/Edit in the SWITCHING > Static MAC Filtering screen to display this screen.
Figure 206 SWITCHING > Static MAC Filtering > Add/Edit
The following table describes the related labels in this screen.
Table 153 SWITCHING > Static MAC Filtering > Add/Edit
LABEL
Active
Name
Action
MAC
VID
Apply
Clear
Cancel
Chapter 47 Static MAC Filtering
DESCRIPTION
Click Add/Edit to add a new entry or edit a selected one.
Click Delete to remove the selected entries.
DESCRIPTION
Enable the switch button to activate your rule. You may temporarily deactivate a rule without
deleting it by de-selecting this check box.
Enter a descriptive name (up to 32 printable ASCII characters excluding [ ? ], [ | ], [ ' ], [ " ] or [ , ]) for
this rule. This is for identification only.
Select Discard source to drop the frames from the source MAC address (specified in the MAC field).
The Switch can still send frames to the MAC address.
Select Discard destination to drop the frames to the destination MAC address (specified in the MAC
address). The Switch can still receive frames originating from the MAC address.
Select Discard source and Discard destination to block traffic to or from the MAC address specified
in the MAC field.
Enter a MAC address in valid MAC address format, that is, six hexadecimal character pairs.
Enter the VLAN group identification number.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
GS1920v2 Series User's Guide
291