Adding Procedures To A Stored Flight Plan - Garmin G2000 Pilot's Manual

Flight ManageMent

adding procedureS to a Stored Flight plan

The system allows the pilot to insert pre-defined instrument procedures from the navigation database into a
flight plan. The procedures are designed to facilitate routing of traffic leaving an airport (departure), arriving at
an airport (arrival), and landing at an airport (approach). See the procedures section for more details.
Stored Flight Plan Name
Stored Flight Plan Waypoint List
DEPARTURE (DP)
A Departure Procedure (DP) is loaded at the departure airport in the flight plan. Only one departure can
be loaded at a time in a flight plan. The route is defined by selection of a departure, the transition waypoints,
and a runway.
Airport Button
Runway Button
Preview Button
Remove Button
256
This manual downloaded from http://www.manualowl.com
Figure 5-101 Edit Stored Flight Plan Screen - Flight Plan Options
Figure 5-102 Departure Selection Screen
Garmin G2000 Pilot's Guide for the Cessna T240
Load Departure Button
Load Arrival Button
Load Approach Button
Departure Button
Transition Button
Departure Waypoint Sequence
Load Button
190-01263-01 Rev. A