Garmin G2000 Pilot's Manual page 139

XPDR IDENT Button– Sends a distinct identity indication to Air Traffic Control (ATC). When selected,the
7
word IDENT is displayed in green and pulsates for the duration of the transmission.
Transponder Settings Button – Displays/removes the Transponder Screen. The Transponder Screen is used
8
to select the transponder mode and code. While the transponder is replying to an interrogation, an R is
displayed on the button.
STBY Button (COM2) – Displays/removes the COM2 Standby Screen. The COM2 Standby Screen is used
9
to enter and transfer COM2 frequencies.
MON Button – Controls which receivers are being explicitly monitored.
10
Function Label – Indicates middle knob function. Typical: Pilot COM1/COM2 Volume, Push: Squelch
11
Function Label – Indicates right large and small knob function. Typical Frequency Entry: COM1/COM2
12
Frequency, Push:1-2, Hold: Typical Data Entry: Data Entry, Push: Enter, Hold:
Middle Knob – Function as labeled (see #12)
13
Large/Small Right Knob – Function as labeled (see #12). Data Entry: Large knob moves the cursor from field
14
to field. Small knob edits character by character. Frequency Entry: Large knob increases/decreases MHz;
Small knob increases/decreases kHz. Press the small knob to confirm the frequency. Press and hold to
transfer the standby frequency to the active frequency.
190-01263-01 Rev. A
This manual downloaded from http://www.manualowl.com
Garmin G2000 Pilot's Guide for the Cessna T240
Audio And CnS
125