Garmin G2000 Pilot's Manual page 226

Flight ManageMent
runway length and/or surface type can be entered to prevent airports with small runways or runways that are
not appropriately surfaced from being displayed. Default settings are 0 feet (or meters) for runway length and
"HARD/SOFT" for runway surface type.
Selecting nearest airport surface matching criteria:
1) From Home, touch Utilities > Setup > Avionics Settings.
2) Touch the System Tab, if necessary.
3) Scroll the list to display the Nearest Airport Runway Surface Button.
4) Touch the Nearest Airport Runway Surface Button to display the surface choices.
5) Touch a surface selection button to set the surface criteria.
System
Tab
Nearest
Airport
Runway
Surface
Button
Selecting nearest airport minimum runway length matching criteria:
1) From Home, touch Utilities > Setup > Avionics Settings.
2) Touch the System Tab, if necessary.
3) Scroll the list to display the Nearest Airport Min Rwy Length Button.
4) Touch the Nearest Airport Min Rwy Length Button to display the keypad.
5) Use the keypad to enter the minimum length.
6) Touch the Enter Button to accept the length criteria.
System
Tab
Nearest
Airport
Min Rwy
Length
Button
212
This manual downloaded from http://www.manualowl.com
Figure 5-44 Nearest Airport Runway Surface Selection
Figure 5-45 Nearest Airport Runway Length Selection
Garmin G2000 Pilot's Guide for the Cessna T240
Surface
Selection
Button
Runway
Length
Entry
190-01263-01 Rev. A