Status And Error Messages - Epson EPL-N2500 Quick Reference Manual

Status and Error Messages

This section contains a list of error messages
shown on the LCD panel, giving a brief
description of each message and suggestions
for correcting the problem. Note that not
every message shown on the LCD panel
indicates a problem. When the
displayed at the left of the warning message,
multiple warnings occur. To confirm all
warnings that occur, press the
button to display the Status Menu, then
press the Enter button.
Cancel All Print Job
The printer is canceling all print jobs in the
printer memory, including jobs the printer is
currently receiving or printing. This
message appears when the
button has been pressed down for more than
2 seconds.
Cancel Print Job
The printer is canceling the current print job.
This message appears when the
Job button has been pressed and released
within 2 seconds.
Can't Print
The print data is deleted because it is
incorrect.
Make sure that the appropriate paper size is
set and a printer driver for EPSON
EPL-N2500 is used.
Can't Print Duplex
mark is
Down
Cart Near Expiry
Cancel Job
Check Duplex P-Size
Cancel
Check Paper Size
EPSON EPL-N2500 Quick Reference
The printer has encountered problems
during duplex printing. Make sure you are
using an appropriate type and size of paper
for the Duplex Unit. The problem could also
be a result of incorrect settings for the paper
source you are using. Pressing the N
Start/Stop button will print the rest of the
print job on only one side of the paper. Press
the Cancel Job button to cancel the print
job.
The imaging cartridge is nearing the end of
its functional life.
Replacing it with a new imaging cartridge is
strongly recommended. See the Reference
Guide for instructions.
The paper size loaded in the printer is not
appropriate for the optional Duplex Unit.
Load correct the paper size and press N
Start/Stop button to resume printing.
The paper size setting is different from the
size of paper loaded in the printer. Check to
see if the correct size of paper is loaded in the
specified paper source.
To clear this error, select Clear Warning
from the control panel's Reset Menu. See
"How to access the control panel menus" for
instructions.
Status and Error Messages (1/5)