Table of Contents
Advertisement
5.14Card Reset
The card can be reset by navigating the browser tree on the left side of the Browser
User Interface to the Reset page as shown in Figure 33.
The administrator can reset the card by clicking the "Yes" button on the Reset
Page.
The card will need to be reset in the following scenarios:
During the install process when the keycode and Multicast settings are being
configured.
If additional ports are configured using a keycode change and a switch
configuration level change.
Before the card is rebooted, the card will backup the current account and parameter
data. This ensures that after reboot the information is up to date.
The data backup task runs every five minutes on the Nortel Remote Agent Observe
Card. If the Card is rebooted through either pressing the faceplate reset button or
through locking latches, any new data generated since the last backup will be lost.
For this reason, it is strongly recommended that the card only be rebooted through
the Browser User Interface Card Reset page or through issuing the command
mirosReboot at the maintenance port command line interface.
Planning, Installation and Administration Guide
Figure 33 BUI Card Reset Page
Nortel Proprietary
73
Advertisement
Table of Contents
