Table of Contents
Advertisement
Nortel Proprietary
Complete the following steps to successfully install the Nortel Remote Agent
Observe Card. Print out these steps and use the provided check boxes to ensure
that all the installation tasks are completed.
STEP 1:
Determine the cabinet, shelf and slot location where the Nortel Remote Agent
Observe card is to be installed. See card slot location section of "Installation
Overview" 11.
STEP 2:
Configure Nortel Remote Agent Observe virtual sets on the Meridian 1/Sucession
1000 system. See "Switch Configuration for Nortel Remote Agent Observe
Sessions" on page 27.
STEP 3:
Connect cables. Refer to "Cabling the Nortel Remote Agent Observe card" on page
16.
STEP 4:
Unpack and inspect the circuit card.
Caution: Handle the circuit card using the guidelines set out in Precautions for
handling circuit cards section in the appendix.
STEP 5:
Check that a security dongle has been installed into the provided socket on the
card. If not already installed, a dongle should be installed into the provided socket.
See Figure 1 for location of dongle socket.
STEP 6:
Fully insert the card in its assigned slot and lock latches. During power-up the hex
LED display provides a visual progress indication of self-tests and provides
information on the first failure detected. Hex display codes are provided in chapter
9 "Test and Debug Capabilities" on page 105.
STEP 7:
The red LED on the faceplate of the Nortel Remote Agent Observe card will
remain lit until a unit has been configured and enabled. So if the red LED is lit, an
error has occurred on one of the previous steps. (The configuring and enabling of
units on the switch should have completed in step 2).
Planning, Installation and Administration Guide
14
Advertisement
Table of Contents
