Configuring The Redundant Atm Uplink Port For Manual Switching - Nortel Passport 8250 Command Line Interface Manual

automatic switching: on
active port: B
primary port: B
Configuring the redundant ATM uplink port for manual
switching
Procedure
1 Display the urconfig parameters to set the active port and primary port
parameters:
urconfig [set]
automatic switching: off
active port: A
primary port: A
2 For the automatic switching parameter, press enter to move to the next
parameter.
3 For the active port parameter, enter B or press enter to accept A.
4 For the primary port parameter, enter B or press enter to accept A.
5 Verify the settings:
urconfig
Example
The following is an example of configuring the redundant ATM uplink port
for manual switching. The primary port and active port is port B. After
configuring the ATM uplink port, the urconfig command is used without the
[set] parameter to verify the urconfig parameters.
[Edgeplex CLI]: urconfig set
automatic switching: off
active port: A B
primary port: A B
[Edgeplex CLI]: urconfig
automatic switching: off
active port: B
primary port: B
Chapter 4 Other activities in the CLI 57
Passport 8250 Command Line Interface Guide R2.2