Table of Contents
Advertisement
28 Chapter 2 Getting started with the CLI
Table 2 (continued)
CLI commands
Command
Where explained
cd <directory path> "Flash file system
commands" (page 70)
clockconfig
NTP 241-5101-200,
Passport 8250
Installation Guide
dir
"Flash file system
commands" (page 70)
exit
"Logging out of the CLI"
(page 26)
faultlogclear
"Deleting entries in the
fault log" (page 64)
faultlogview
"Viewing entries in the
fault log" (page 63)
help
"Getting help in the CLI"
(page 25)
ibconfig
"Configuring the ATM
uplink port for in-band
management" (page 54)
info on|off
"Viewing alarm and
information messages"
(page 61)
map
"Creating connections"
(page 37)
mshow
"Searching by port
number" (page 46)
passwd
"Changing the password"
(page 24)
ping <host IP>
"Checking for network
connectivity" (page 53)
portconfig
"Modifying port settings"
(page 33)
(Sheet 2 of 3)
241-5101-201 R2.2
Description
Change the directory in flash memory.
Display and configure the reference clock.
Display the files in the current directory in flash
memory.
Terminate a CLI session.
Delete the contents of the fault log.
View the entries in the fault log.
Display a list of the CLI commands or the syntax
of a specified CLI command.
Display and set the ATM uplink port for in-band
management.
Enable or disable the display of the information
messages in the CLI. The default is off.
Map connections to ports.
View ports with connections.
Change the password.
See if a remote host is reachable.
Display and change the line type, line coding,
and signal mode for a port.
Advertisement
Table of Contents
