Table of Contents
Advertisement
50 Chapter 3 Provisioning ports and connections
2
3
Example
The following is an example of unmapping the connections mapped to ports
10, 11, and 12 on service board 2. Before unmapping the connections, the
mshow command is used to verify that the connections exist.
Example
The following is an example of unmapping the connections to port 6 on
service board 2. Before unmapping the connection, the mshow command is
used to verify that the connection exists.
241-5101-201 R2.2
Verify that the connections exist:
mshow [<port#i>[,<#j>]
Delete the connections:
unmap <port#i>[,<#j>]
[Edgeplex CLI]: 2
[E1-2]: mshow 10,12
vpi=20 vci=50 -> card=2 port=10 channel(s)=0x0000fffe
vpi=20 vci=51 -> card=2 port=11 channel(s)=0x0000fffe
vpi=20 vci=52 -> card=2 port=12 channel(s)=0x0000fffe
[E1-2]: unmap 10,12
unmapped port 10 channel(s)=0x0000fffe from vpi=20
vci=50
unmapped port 11 channel(s)=0x0000fffe from vpi=20
vci=51
unmapped port 12 channel(s)=0x0000fffe from vpi=20
vci=52
[Edgeplex CLI]: 2
[T1-2]: mshow 6
vpi=200 vci=30 --> card=2 port=6 channel(s)=0x00ffffff
[T1-2] : unmap 6
unmapped port 6 from vpi=200 vci=30
Advertisement
Table of Contents
